Author Topic: Bypassing SilverTron Elites Automatic Shutoff  (Read 1161 times)

Offline kephra

  • The older I get, the better I was
  • Administrator
  • Participant
  • *****
  • Posts: 7668
  • Likes: 118
  • Illegitimi Non Carborundum
Bypassing SilverTron Elites Automatic Shutoff
« on: April 23, 2017, 12:45:02 PM »
Suppose that you wanted to brew a batch of Colloidal Silver to some strength or volume that is not in the SilverTron's menus.  Perhaps you wanted to make 1 gallon of 100 ppm but there is no menu choice for that combination.  One way to do that is to bypass the auto shutoff system and use the SilverTron as a constant current system.

To do that, simply set the ppm and volume to the maximum, 4 liters and 320 ppm.  Then you would calculate a run time based on your mA setting and time the run. 

Calculate the run time:  Minutes = (ppm * ml * .015) / mA.

Colloidal Silver is only a bargain if you make it yourself.

Offline Dean

  • Expert
  • Participant
  • ***
  • Posts: 507
  • Likes: 38
    • Social SilverTron Facebook Portal
Re: Bypassing SilverTron Elites Automatic Shutoff
« Reply #1 on: October 24, 2017, 07:31:54 PM »
This is an interesting one. Although I have to be honest, with 1 litre of 320 pressing towards 6 hours with set up time and such like, I’m not sure that I can be around to monitor it for larger quantities.

Once again though, just another reason that the Silvertron knows no bounds (well almost  8) )