Author Topic: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron  (Read 9601 times)

Offline RedDogJT

  • Participant
  • **
  • Posts: 198
  • Likes: 8
  • Information junkie & autodidact
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #165 on: May 06, 2020, 05:50:06 PM »
THANK YOU! LOTS OF GOOD INFORMATION IN ONE PLACE!
Nothing is as it seems and nothing is at it appears

Offline PhiPhi

  • Participant
  • **
  • Posts: 51
  • Likes: 1
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #166 on: May 07, 2020, 07:07:25 AM »
@cfnisbet Thank you so much for making this thread the information is invaluable.  I have one one small suggestion.

It would be helpful to give quantities in metric and imperial.  8 fluid ounces UK =  227.30ml whereas 8 fluid ounces US = 236.59ml.  Metric measurements are easier on the mental arithmetic and the imperial measurements are confusing, I still remember using imperial at school but by 1972 I'd had it more or less beaten out of me.

Yes, I'll do that in future. The members from the USA mainly use US Imperial, so I'll use both from now on.
« Last Edit: May 07, 2020, 02:23:31 PM by cfnisbet »
Many have said of Alchemy, that it is for the making of gold and silver. For me such is not the aim, but to consider only what virtue and power may lie in medicines.

Paracelsus

Offline imcool

  • Participant
  • **
  • Posts: 204
  • Likes: 3
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #167 on: May 12, 2020, 06:07:47 AM »
FOR THE ADVANCED STUDENT: THE MAKING OF 320 PPM COLLOIDAL SILVER & GEL CAPPING TIPS

From Kephra's other posts on the subject:-

*snipped for brevity*

I did not understand this warning below:
""B)
320 ppm Gelatin Capped Metallic colloidal silver

Warning:  Should be diluted to 20 ppm before use.
250ml cold distilled water
1.0 gram or 1/4 tsp Knox unflavored gelatin
Electrode spacing 1.5 inches
Add 5 drops 1M Sodium Carbonate
Add 15 drops clear Corn Syrup (diluted 1 to 1 with distilled water)
Electrolyze 80 minutes @ 15ma
Constant stirring and heat required.  Heat water to a simmer (about 200F)""

Can someone kindly explain it to me, what does the warning mean?

Does it mean that whenever we use 320ppm we must dilute it to 20ppm and then use it?

or does it mean something else in regards to gel capping 320ppm while making it?

Thank you
« Last Edit: May 30, 2020, 09:30:28 AM by cfnisbet »

Offline wgpeters

  • Kephra's other account
  • Expert
  • Participant
  • ***
  • Posts: 634
  • Likes: 75
    • SilverTron Support
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #168 on: May 12, 2020, 12:11:28 PM »
Quote
I did not understand this warning below:
""B)
320 ppm Gelatin Capped Metallic colloidal silver

Warning:  Should be diluted to 20 ppm before use.
I placed the warning on high ppm silver simply because no one knows the exact transport mechanism from inside the gut to the blood stream.  For instance, the human body has a limit as to how much vitamin C it can absorb because the gut runs out of the transport molecules.  Since this was/is unkown, I thought the warning appropriate.
A person's worth is solely determined by what he does for others.

Offline imcool

  • Participant
  • **
  • Posts: 204
  • Likes: 3
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #169 on: May 12, 2020, 03:21:16 PM »
Quote
I did not understand this warning below:
""B)
320 ppm Gelatin Capped Metallic colloidal silver

Warning:  Should be diluted to 20 ppm before use.
I placed the warning on high ppm silver simply because no one knows the exact transport mechanism from inside the gut to the blood stream.  For instance, the human body has a limit as to how much vitamin C it can absorb because the gut runs out of the transport molecules.  Since this was/is unkown, I thought the warning appropriate.
Alright, I get it, its for consumption. Thanks so much.

Offline Turbidaceous

  • Participant
  • **
  • Posts: 398
  • Likes: 1
  • Living in the UK
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #170 on: May 17, 2020, 11:32:21 PM »
Quote
I did not understand this warning below:
""B)
320 ppm Gelatin Capped Metallic colloidal silver

Warning:  Should be diluted to 20 ppm before use.
I placed the warning on high ppm silver simply because no one knows the exact transport mechanism from inside the gut to the blood stream.  For instance, the human body has a limit as to how much vitamin C it can absorb because the gut runs out of the transport molecules.  Since this was/is unkown, I thought the warning appropriate.

Isn't 20ml of 100ppm the same as 100ml of 20ppm? Either method of consumption yields 2mg of silver. Unless I am not understanding something?

Offline PhiPhi

  • Participant
  • **
  • Posts: 51
  • Likes: 1
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #171 on: May 25, 2020, 01:19:49 PM »
The concern with the concentration is uncertainty on the body's uptake capacity, rather than risking overrunning what ever mechanism transports the AgNP's into the bloodstream with high ppm Colloidal Silver a lower concentration at higher volume is likely to be less taxing on it and possibly benefit with a higher % uptake. 
Many have said of Alchemy, that it is for the making of gold and silver. For me such is not the aim, but to consider only what virtue and power may lie in medicines.

Paracelsus

Offline e11

  • Participant
  • **
  • Posts: 16
  • Likes: 1
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #172 on: May 29, 2020, 08:57:20 PM »
I bought sodium bicarbonate and tried to cook it in a steel pot, before transferring it into an oven bowl and had it in for an hour at a high gas mark 8 with no real change. Kept opening the oven every 10 minutes to check. How do you guys do yours?
« Last Edit: May 29, 2020, 09:33:33 PM by e11 »

Offline wgpeters

  • Kephra's other account
  • Expert
  • Participant
  • ***
  • Posts: 634
  • Likes: 75
    • SilverTron Support
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #173 on: May 29, 2020, 10:02:09 PM »
What did you expect to happen? 
A person's worth is solely determined by what he does for others.

Offline bcboy

  • jack of all master of none
  • Participant
  • **
  • Posts: 96
  • Likes: 2
  • Okanagan Valley
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #174 on: May 30, 2020, 04:17:31 AM »
 ???
« Last Edit: May 31, 2020, 05:07:05 AM by bcboy »
:D One day at a time.

Offline e11

  • Participant
  • **
  • Posts: 16
  • Likes: 1
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #175 on: June 04, 2020, 03:27:31 PM »
What did you expect to happen?

I expected the powder to bubble slightly as the carbon dioxide and water escaped during the heating process. From the videos I watched this was done on a steel pot and they bubbled up.

The process I did was bake 50 grams of sodium bicarbonate in the oven for an hour, then put 30 grams of the powder into a 300ml bottle of distilled water. I've kept this in the fridge, ready to use for 2nd attempt

Offline Smoke7

  • Participant
  • **
  • Posts: 51
  • Likes: 3
  • "A picture is worth 1000 words"
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #176 on: June 07, 2020, 09:05:22 PM »
Thanks for your  Help, I will only be using it to make my 20ppm Colloidal silver Asper the new tutorial .

I will update once All items arrives .

Ed

Hello Ed.
I found your silver generator instructional, great video.
I have two suggestions for you (The first one is my personal opinion). I would not use a metal thermometer in the silver, I always use a glass thermometer. The second suggestion is more mandatory about your current controller. I saw the current was jumping up and down from 5 to 7mA and stopped at the 7mA. Sounds like your current controller is set by voltage and not by current. If you lock it by the current the voltage can go up and down but the current stays at the point you locked it or less but not over the limitation. In your case it is 5mA. Set your device by current limitation not by voltage.

"An ounce of prevention is worth a pound of cure"

Offline cfnisbet

  • Administrator
  • Participant
  • *****
  • Posts: 2008
  • Likes: 115
Re: HOW TO MAKE COLLOIDAL SILVER if you can't get a SilverTron
« Reply #177 on: June 08, 2020, 08:34:47 PM »
This thread is now locked; only because other follow-up questions would be better dealt with in their own thread. This thread will remain as a constant "sticky" for others to follow. The questions after page one, I hope, will answer some of the most common questions; if they don't by all means start a new thread in the appropriate section.
« Last Edit: June 08, 2020, 09:07:01 PM by cfnisbet »