Author Topic: 320 ppm x 200F???  (Read 75 times)

Offline pimentel5000

  • Participant
  • **
  • Posts: 19
  • Likes: 0
320 ppm x 200F???
« on: August 23, 2020, 04:47:37 AM »
Friends, to make colloidal silver at 320 ppm the temperature of 200F needs to be maintained from the beginning to the end of production?

Offline cfnisbet

  • Administrator
  • Participant
  • *****
  • Posts: 2016
  • Likes: 115
Re: 320 ppm x 200F???
« Reply #1 on: August 23, 2020, 12:59:23 PM »
A low simmer is the temperature required. 200 degrees F is a bit high; it will work, but evaporates water too fast and wastes energy. 80 degrees is more than adequate. Watch for bubbles appearing in the bulk fluid but disappearing before they get to the surface; this is the maximum needed.

The minimum temperature for hot production is that temperature required to cause convection currents; this helps to stir the water.

Offline pimentel5000

  • Participant
  • **
  • Posts: 19
  • Likes: 0
Re: 320 ppm x 200F???
« Reply #2 on: August 24, 2020, 12:50:03 AM »
Got it, I will do that. good to know about 80 degrees celsius. Thank you!!